1. Injection molding machine parts lubrication

As this part of the injection is complete dual cylinder pulling pre-plastic gear box, gear box driven by a screw, uniform plasticized film cavity plastic injection molding machine, the implementation of a key component injection molding. Movement more frequently, there are electric heating device, the lubrication system must be strictly enforced. The main part of the lubricating parts:

⑴ injection seat and rack rail surface plus L-AN46 Total loss system oil, once per shift.

⑵ the bottom of the gearbox (pins) rail surface plus L-AN46 Total loss system oil, once per shift.

⑶ rotation center plus oil, approximately 0.3L.

⑷ speed gear box plus L-AN46 oil system-wide loss of about 10L.

2. Injection molding machine parts lubricated shift

Hydraulic power shift mode, use direct pressure filling device, simple structure, reliable operation, less lubrication points. Mainly to ensure the four-column guide lubricant film formation, can be L-AN46 machine oil through the oil cup, wick lubrication.

3. The injection molding machine motor lubrication

Automatic hydraulic injection molding machine mostly by more than one motor drive, during routine lubrication, the motor should be lubricated as required.

On the injection molding machine of recycled plastic

Alina