all electric injection moulding machine

On our planet, every day was taken away by the immense heat of the flue gas, environmental pollution is staggering. How injection molding machine industry energy conservation, improve the working environment, reduce the temperature of the injection molding machine shop is a concern. Waste heat recovery injection molding machine is an important aspect of energy conservation work, if all of the flue gas heat recovery are performed, its cost is very impressive.

1. Energy Saving Injection Molding Machine

Existing injection molding machine is equipped with systems for plastic dehumidifying dryer, electric heating mode to provide heat, carry a certain amount of heat from the exhaust outlet air heat drying drums, when this part of the heat directly into the workshop, a workshop area will increase the dust content in the air and affect the operation of the health of workers, on the other hand will increase energy consumption and increase the financial burden on businesses.

In the case of lack of prior art, this article provides an injection machine heat recovery heat cycle apparatus, melt rubber tube around the heating section to install waste heat collection device when utilizing the heat of the work dried plastic tub and dried dehumidifying.
Have some water, dust and hot air is discharged from the injection molding machine, hot air circulating through the duct into the dust dehumidifying apparatus, processes, through the hot part of the subsequent adjustment of fan heat, provide the impetus for an injection molding machine heat so as to generate the flow loop, after treatment into the injection molding machine, and then circulated through the plastic barrel and heat entering the heat further heat treatment; another portion of hot air and the heated gas 2 have been an injection molding machine, which can adjust the temperature of the injection molding machine within through which air flow to ensure that the actual injection molding machine with a set temperature, respectively. When the temperature inside the injection molding machine than the set low signals, increasing the output of wind speed increase in driving action, into the injection molding machine, the air temperature increases, the temperature rise inside the injection molding machine, when in the injection molding machine temperature than the set temperature is high, a signal, reduce speed and reduce the output of wind, thus reducing high-temperature gas into the injection molding machine, the temperature of the injection molding machine is lowered.

2. Injection molding machine waste heat utilization Problems and Suggestions

These problems are:

(1) of the injection molding machine processing enterprises throughout the country, but the equipment skill levels, a lot of business equipment needs further transformation;

(2) ban plastic industry voices, but in the rural market is still widely used plastic products, cutting costs has become a top priority for enterprise development;

(3) Due to the dissemination of information channels and lack of funds business, which greatly restricted the lot to promote this technology, many enterprises lack advanced energy-saving technologies and mechanisms for clean development mechanism, advanced technology service providers have no way to understand the situation of enterprises;

(4) injection molding machine high temperature waste heat utilization technology after years of development is now more mature, successful cases also showed its economic benefits, but the huge potential of low temperature waste heat utilization injection molding machine needs to be further developed.

bakelite chemistry injection molding machine

Alina